Sie sind nicht angemeldet.

Lieber Besucher, herzlich willkommen bei: Amorphophallus-Forum.de. Falls dies Ihr erster Besuch auf dieser Seite ist, lesen Sie sich bitte die Hilfe durch. Dort wird Ihnen die Bedienung dieser Seite näher erläutert. Darüber hinaus sollten Sie sich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutzen Sie das Registrierungsformular, um sich zu registrieren oder informieren Sie sich ausführlich über den Registrierungsvorgang. Falls Sie sich bereits zu einem früheren Zeitpunkt registriert haben, können Sie sich hier anmelden.

1

Mittwoch, 5. Oktober 2011, 13:40

A. konjac - 2 Blätter + 3. Trieb

Hello together,

I have today at one of my small A. konjac in which is a subsidiary bulb 2010 discovered the following:



The plant had pushed shortly after the expulsion of the 1st leaf spring a significantly smaller sheet up and also all the time both keep. Today, I see that the plant probably makes a further sheet foliation in recent weeks.

Thought no more than two sheets going it at the same time. Should I take the plant to the flat and look whether she still through engineered the third leaf?

Thank you - LG, Robert

2

Mittwoch, 5. Oktober 2011, 13:50

Ohje, which is far too high planted! :icon_eek: The bulb could make roots only on one side, because it was covered with Earth on the other.

Of course, it powers through the third leaf still if the environmental conditions allow it. 2 Leaves are never the upper limit, I had a konjac with 4 sheets last year and this year one with 3 leaves. However, there is this only for younger tubers:icon_wink2:

3

Mittwoch, 5. Oktober 2011, 13:54

Hello Oldi,.

don't worry - the Earth was set free only for the photo to the tuber.

Used to have the info that there is A. konjac maximum of two leaves. That is why I had surprised me. Then this statement not agreed but easy.

Is yes then so does;)

Thank you - LG, Robert

4

Mittwoch, 5. Oktober 2011, 13:58

Before I clickte on the reply button there... was still no response from the response speeds here, can slowly so some customer service cut off a disc itself.:D

Which I once again the urgent notice: the tuber must sit lower and should be completely covered with substrate! A gross basis for this is that the tuber should sit at least as deep as it is high.

5

Mittwoch, 5. Oktober 2011, 13:59

Okay, it's funny but yet that no roots are seen on a page.
For me there's currently a few tuber, who believe that having to drive now :D playing is such tubers....
Ahrscheinlich is located on the summer weather until yesterday:icon_wink2:

6

Mittwoch, 5. Oktober 2011, 14:07

Hello

was then probably really just too high planted. Must admit that I have respected this year when the whole young nodules not so bad on it since. Some sit deeper and some like the one pictured tuber sit just under the surface of the substrate. Times look if that makes its presence felt in the tuber size.

Thank you - LG, Robert

Ähnliche Themen

Übersetzen:

  Deutsch  Englisch  Dänisch  Spanisch  Persisch  Französisch  Kroatisch  Italienisch  Japanisch  Niederländisch  Polnisch  Russisch  Schwedisch  Türkisch 

Translation powered by Bing Translation

Sie sind nicht angemeldet. | Anmelden | Registrieren | Passwort vergessen ?